Another Fuji problem

[Mike Firth]

Well, I set up my first ramp cycle, etc. Did good. Checked it carefully before and during.
Now, I want to use it again and it won't let me. Stat say it is at End, but when I go to Prog, it won't let me change to Run. And I can't change the set point either.
I suspect the problem is that I did the final set point at 32C (about 90F) which I keep the annealer at to keep it dry and it hasn't gotten down that low, so I wonder if it hasn't "released"
What do I do to break it out now and what should I set to prevent this in the future? I have Mod set to the default, I found the message about using 4 after I came in.

[Steve Beckwith]

I think that you have to hit the SEL to PROG then select off first.

[Brian Gingras]

yes set to off first and it will (usually) revert to it's last manual set point. Thats how we use our annealer...when i hit off it ramps up for the day, and then run brings it down.

[Tom Bloyd]

Push sel and then data and change it to off and then put it into run

[Mike Firth]

Thanks all, that's great, worked fine. Of course, looking at the directions doesn't suggest that you have to turn program off to finish the process.
Take a look at the thread Dallas Glass Studio Open Houses, Nov. 17th if you are anywhere in the area - not including me.