View Single Post
  #4  
Old 02-11-2019, 06:56 PM
Kenny Pieper Kenny Pieper is offline
Registered User
 
Join Date: Feb 2003
Location: Burnsville N.C.
Posts: 826
Kenny Pieper is on a distinguished road
this can only be done if the piece is relatively thick and the kiln is pretty powerful. you have to bring the piece from annealing temp up to a softening point, hold there till the surface starts to soften and then bring back down to annealing temp before the piece starts to slump.
Eben's suggestion of picking the piece back up and fire polishing in the gloryhole or torch is a good one
Reply With Quote