As fate has it I was about to ask a similar question, but mine was this. Who has the best deal on 220v (and above) mig welder with gas hoses and regulator? Can I get a lincoln, miller, or hobart and not spend more than $850 out the door ? Should I even look @ a tig?
What about horizontal metal cutting band saws? How much do I need to spend to get a "decent" one? Delta? Has any recently purchased a set of rollers? I was looking @ these
http://www.bossbendersusa.com/ringroller.htm any other suggestions?
I am over chop saws and stick welders, but will always need a oxy-acetylene rig and a belt/disk sander...
Warm Regards,
Andy
www.brottworks.com
p.s. 6011 is for penetrating, 6013 is for filling, and mig does both...