View Single Post
  #61  
Old 01-06-2011, 09:42 PM
Lawrence Duckworth Lawrence Duckworth is offline
Registered User
 
Join Date: Mar 2010
Location: Gainesville, GA
Posts: 677
Lawrence Duckworth is on a distinguished road
what would you folks think of a design that seperates the furnace body from the floor. this design could use off-the-shelf 3" thick castings.

anyone have any idea how hot the backside of the 3" thick casting is in normal operating use?

is 2.5 inches enough clearance between the pot and wall castings for moly tubes?

Last edited by Lawrence Duckworth; 03-03-2014 at 05:41 AM.
Reply With Quote