CraftWEB Hot Glass Talk  

Go Back   CraftWEB Hot Glass Talk > Hot Glass > General Hot Glass Discussion

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 10-09-2018, 03:04 PM
Richard Huntrods's Avatar
Richard Huntrods Richard Huntrods is offline
Registered User
 
Join Date: Aug 2003
Location: Vancouver Island
Posts: 1,142
Richard Huntrods is on a distinguished road
Heating Refractory

My furnace is off right now due to either a loose wire, controller failure, or thermocouple problem.

Symptom: it was holding idle temp no problem (1900F). When I'd get ready to blow, I'd ramp up to 2100. At 2000, the temperature display suddenly flipped from actual to UUUU (so one of the above most likely causing it). This shut off the power to the elements until things dropped to under 2000, then it would come back on and try and recover. As I was there, I watched it happen a few times then shut it off as I was near my annual maintenance window anyway.

The most obvious suspect based on what happened is a loose thermocouple wire or connection. These things can work their way loose over time.

My plan is to tighten the connections on all the wires, and then fire up the furnace. Basically if it's a high temp (over 2000F) problem, no amount of low temp fussing will find it.

The elements have been checked and are all fine, as is power to the elements.

I want to bring the furnace up to 2100 quickly.

The crucible is out of the furnace right now as part of the overall maintenance, so the furnace is just K23, fiberfrax and alumina board.

Can I fire this up to 2000 without stopping for hours at the inversion point (900-1300F)? That is, does refractory also need to be babied through the quartz inversion or can I just crank it up? Is there a 'best ramp rate" to follow with just refractory?
Reply With Quote
 


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off
Forum Jump


All times are GMT -5. The time now is 01:34 AM.


All published comments within these message boards are the opinions of its contributor and does not represent
the opinion(s) of the owner(s) of this website. Please see the Terms of Use file for more details.

Books to Help Artists Avoid Online Scams: Top 10 Email Scams | Social Media Scams

Powered by vBulletin® Version 3.7.2
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
CraftWEB.com. Opportunity Network. 2008. All Rights Reserved.