![]() |
#1
|
|||
|
|||
Watlow EZ
Greetings,
My Watlow 981 on my annealehr finally bit the dust. I replaced it with the Watlow EZ. I am learning a bit on programming but it is not sure intuitive. Has anyone programmed an annealing cycle with one of these? Can you walk through the steps involved? Thanks, Andy
__________________
Keep It Centered http://aboatman.blogspot.com http://bluesagestudios.blogspot.com |
#2
|
|||
|
|||
Send it back for a refund and buy a SOLO control for $90.00 from automation direct. It will be intuitive to program with an easily read guide and phone help.
__________________
If all you wanted to do was express yourself artistically, you should have obtained a field watercolor set and a pad of acid-free paper. You chose a media with INFRASTRUCTURE baby! |
#3
|
|||
|
|||
Quote:
You can add a usb port to most of the cheap $!00 one as well.
__________________
candlewoodglass@gmail.com |
#4
|
|||
|
|||
I did the same about a year ago, I called Watlow and their tech walked me thru doing the programming step by step for 30 minutes plus on the phone.
Worked flawlessly so far. Dan |
#5
|
||||
|
||||
Watlow does have good customer support.
__________________
"It's such a fine line between stupid and clever." - David St. Hubbins |
![]() |
Thread Tools | |
Display Modes | |
|
|